Skip Navigation Website Accessibility





 


Berp for Small Trombone/Euphonium

BERP (Buzz Extension Resistance Piece) for small trombone/euphonium. You clamp it to your instrument receiver, insert your mouthpiece, and use the resistance dial to change the blow.

FROM BERP:

birth of the berp

One of the leading proponents of buzzing the mouthpiece was James Stamp. I had the great honor of studying with Jimmy while I was a member of the Los Angeles Philharmonic, and his teachings influence the exercises and practice suggestions that make up the berp concept. He had students add resistance to the mouthpiece when buzzing by either placing their little finger over the end or adding a rubber electrical extension called an “alligator clip.” By learning to blow into resistance, you become more aware of undesirable resistance in your body, and learn how to avoid it by using proper breath support. Jimmy also asked us to finger the valves of our instruments while buzzing the mouthpiece, to make us aware of the connection between the fingers and the brain’s perception of pitch. I put the two ideas together, buzzing and fingering (or moving the slide) to the corresponding pitch, to maximize the benefits for my students and myself.

- mario guarneri, inventor of the berp

how to berp

The clamp. The Berp clamp fits firmly onto the open end of the instrument’s receiver, with the mouthpiece removed. It’s designed to tighten around a round, hex, or convex-shaped opening. If a receiver has an oversized ring at the opening, it may be necessary to push the clamp past that before tightening down. For some receivers, you may also need to add black electrical tape to the inside of the clamp to help prevent slippage and ensure a secure fit. Most people prefer to line The Berp up parallel to the receiver at the “three o’clock” position. You may want to experiment with other positions to determine what’s best for you. Once The Berp is firmly attached, you can easily alternate between buzzing and playing your instrument by switching the mouthpiece.

The resistence dial. The dial for the trumpet, horn, and cornet Berp should be positioned below the holes and pushed up to partially cover them to create the desired resistance. The dial on The Berp for trombones, euphoniums, and tubas should be positioned above the holes and lowered to create the desired resistance. Beginners usually have a better chance of getting a good buzz with slightly more resistance. Once a good buzz is achieved, resistance on The Berp should be dialed similarly to that of the instrument.